devnp-msk.so

Driver for Marvell Yukon-2 based Gigabit Ethernet adapters

Syntax:

io-pkt-variant -d msk ... &

where variant is one of v4, v4-hc, or v6-hc.

Runs on:

Neutrino

Options:

None

Description:

The devnp-msk.so driver supports the Marvell Yukon-2 based Gigabit Ethernet adapters, including the following:

• Marvell Yukon 88E8035, copper adapter
• Marvell Yukon 88E8036, copper adapter
• Marvell Yukon 88E8038, copper adapter
• Marvell Yukon 88E8050, copper adapter
• Marvell Yukon 88E8052, copper adapter
• Marvell Yukon 88E8053, copper adapter
• Marvell Yukon 88E8055, copper adapter
• SK-9E21 1000Base-T single port, copper adapter
• SK-9E22 1000Base-T dual port, copper adapter
• SK-9E81 1000Base-SX single port, multimode fiber adapter
• SK-9E82 1000Base-SX dual port, multimode fiber adapter
• SK-9E91 1000Base-LX single port, single mode fiber adapter
• SK-9E92 1000Base-LX dual port, single mode fiber adapter
• SK-9S21 1000Base-T single port, copper adapter
• SK-9S22 1000Base-T dual port, copper adapter
• SK-9S81 1000Base-SX single port, multimode fiber adapter
• SK-9S82 1000Base-SX dual port, multimode fiber adapter
• SK-9S91 1000Base-LX single port, single mode fiber adapter
• SK-9S92 1000Base-LX dual port, single mode fiber adapter
• SK-9E21D 1000Base-T single port, copper adapter

This is a ported NetBSD driver; its interface names are in the form mskX, where X is an integer.

Support for jumbo frames is provided via the interface MTU setting. Selecting an MTU larger than 1500 bytes with the ifconfig utility configures the adapter to receive and transmit jumbo frames. Using jumbo frames can greatly improve performance for certain tasks, such as file transfers and data streaming.

Hardware TCP/IP checksum offloading for IPv4 is supported.

The following media types and options (as given to ifconfig) are supported:

media autoselect

Enable the autoselection of the media type and options. You can manually override the autoselected mode.

media 1000baseSX mediaopt full-duplex

Set 1000Mbps (Gigabit Ethernet) operation on fiber and force full-duplex mode.

media 1000baseSX mediaopt half-duplex

Set 1000Mbps (Gigabit Ethernet) operation on fiber and force half-duplex mode.

media 1000baseT mediaopt full-duplex

Set 1000Mbps (Gigabit Ethernet) operation and force full-duplex mode.

For more information on configuring this device, see ifconfig. To view a list of media types and options supported by the card, try ifconfig -m device. For example, ifconfig -m msk0.

See also:

devn-*, devnp-*, ifconfig, io-pkt